admin

February 24, 2021

Observing several guidelines for correct set up is crucial towards the trustworthy and right operation in the gearbox or gear motor.
The guidelines set out here are meant as being a preliminary guidebook to selecting gearbox or gear motor. For efficient and good installation, follow the instructions offered inside the installation, use the maintenances guide for your gearbox out there from our revenue division.
Following is usually a quick outline of installation rules:
a) Fastening:
Location gearbox on the surface giving adequate rigidity. Mating surfaces ought to be machined and flat.
Mating surfaces must be inside of definite geometric tolerances (see guide). This can be in particular true of flange-mounted gearboxes with splined hollow shafts.
In applications that involve high radial loads with the output end, flange mounting is advisable for some gearbox sizes as this mounting helps make utilization of the double pilot diameters offered in these gearboxes.
Ensure the gearbox is suitable for your demanded mounting position.
Use screws of resistance class 8.eight and above to safe the gearbox. Torque up screws for the figures
indicated during the relevant tables.
With transmitted output torque greater than or equal 70% with the indicated M2max torque, and with
frequent movement reversals, use screws with minimal resistance 10.9.
Some gearbox sizes might be fastened working with both screws or pins. Of pin seated inside the frame the gearboxes be at the least 1.5 occasions pin diameter.
b) Connections
Secure the connection parts to gearbox input and output. Tend not to tap them with hammers or comparable resources.
To insert these parts, make use of the support screws and threaded holes supplied about the shafts. Be sure you clean off any grease or protects through the shafts ahead of fitting any connection parts.
Fitting hydraulic motors.
Be cautious the O ring between motor flange and gearbox input flange when assembling. Set up the
hydraulic motor in advance of filling lube oil into the gearbox.
Connecting the hydraulic brake.
The hydraulic circuit needs to be this kind of to ensure that brake is launched instants before gearbox begins and applied after gearbox has stopped. Check that strain in the hydraulic line for brake release is at zero whenever gearbox is stopped.
Path of rotation
Motors are connected on the ideal electrical or hydraulic circuit as outlined by their course of rotation.
When carrying out these connections, keep in mind that all gearboxes, no matter if within the in-line or appropriate angle design and style, possess the similar course of rotation the two at input and output. For much more specifics in the connection of electric and hydraulic motors, see appropriate sections on this catalogue.